Eliminate the Old Drain Assembly
Loosen and remove the P-trap through the branch drain and sink drain tailpiece, making use of channel-type pliers. Next, remove the pop-up that is old, when there is one. Utilize channel-type pliers or perhaps a basin wrench to remove the mounting nut through the tailpiece from the old drain installation, then carry the installation free from the sink. Clean the sink completely of debris and old plumber’s putty.
Prepare the brand new Pop-Up Drain Stopper
Disassemble the pieces for the new assembly that is pop-up and unscrew and remove the mounting nut through the drain tailpiece. Install the plastic washer then your plastic washer and push all of them the means down along with the mounting nut, as shown right right right here.
Apply Pipe Joint Compound
Apply a slim layer of pipeline compound that is joint the most truly effective side for the plastic washer that may fit up against the sink. Utilizing compound that is joint the plastic will make sure that it seals contrary to the base for the sink drain opening. While pipeline joint element is maybe perhaps not strictly necessary, without one it’s likely you have difficulty obtaining the plastic to seal.
Apply Plumber’s Putty
Apply a good bead of plumber’s putty to the lower associated with flange in the sink drain ring. The putty may help the part that is upper of drain construction seal resistant to the sink drain opening.
If you don’t have plumber’s putty or cannot utilize it on your own variety of sink, you’ll be able to make use of silicone caulk. Some assemblies that are pop-up with a foam or plastic gasket to utilize instead of plumber’s putty or caulk. Leia mais